skodapilot Forum

To make a test setup I´m searching for what signals need to go to the cluster
Brakepadweare is 15 on the cluster
Parkingbrake is pin 25 on the cluster.
but what signal do they need to test the lamps in the cluster?
are those signals only mass or do I need to supply 12Vdc positive on these pins

No one who knowes?
Then I guess it will be trial and error.

So I tried it on old cluster and succeeded. All lights in the cluster except engine are out now.
The following pins i have connected to mass.
Pin 11 Oil temp
Pin 15 brake pads
Pin 17 front screen wash
Pin 18 coolant temp
Pin 25 parking brake
Pin 26 brake flued
Pin 27 Oil pressure

Next step is to install some pushbuttons to open the circuit, so the light actually comes on.
This will make my test setup complete.