skodapilot Forum

Hello Dear Friend

I own a 2013 polo 6R 1.2 TDi
I have buy amarok cluster and it is working.
But now I'm searching for can modify the eeprom to fix. wheel circumference, braking fluid floater, fuel gauge and pictograph to fit the Polo 6r

Amarok cluster 2H0920871B
SW1009
HWH04
21/09/2015
Amarok cluster
2H0920871B
SW 1009
HWH 04
21/09/2015
eeprom 24LC64E

Yes, it is possible:

• using dump from our online EEPROM database as reference source
• by modification of certain parameters (circumference, scale layout and etc)

Hi everyone, I've done the amarok dashboard swap on my polo. Thanks to VDOEditor I've almost adapted the dashboard to my car, there are some area that VDOEditor doesn't covers, specifically in the case amarok -> polo, brake fluid level warning NC NO type, boot lid open warning and indirect TPMS warning.

In the case of brake fluid level at 0x2cb bit 3 changes the logic.

Maybe because Amarok is a pickup, they have disabled the boot lid open warning, the can signaling is correctly received in the dashboard like IDE00303-MAS00222 says.

Someone knows at which offset lies this setting?

About TPMS, with the old dashboard when I had a tyre pressure dtc in ABS the flat wheel warning was showed in it. With the new dashboard and the same dtc it shows nothing.
Thanks

Polo 6R 1.2 TDI
I buy Amarok cluste
I want to install in polo can you help me for editing Brake fluid , speed signal , boot lid , fuel tank , low fuel warning , picture
Sw/ 1009
Hw/ h04
Can you help me
I buy software

See my upper post and make modification according gelotus comment

Bump , do we know what the tailgate byte is ?

Hey there,

I have the same problem. Swapped dash one year ago and adpated it. Everything works fine except except the boot lid. Probably the Flat wheel warning as well.

I'm bothered so much driving around like this for a year now already.

@gelotus coud you please help? I would donate to you also.