Has this been disabled?
I have a eeprom where this is enabled and I want to disable it, but I don't know offset.
No Support Menu option in VDO Editor 2
-
- Posts: 7
- Joined: 22 Jul 2016 00:19
Re: No Support Menu option in VDO Editor 2
Should of read more....
Address is 0x67 Bit1 - Support Menu Enabled.
Address is 0x67 Bit1 - Support Menu Enabled.
-
- Site Admin
- Posts: 464
- Joined: 13 Jan 2014 06:18
Re: No Support Menu option in VDO Editor 2
Yes, this option was removed from build-in list as it is available to adjust via adaptation channel.
You can add section to custom settings for Mcu -> Nec850, Eeprom ->I24C64, Type->Unknown in group BITS
So, you can easy access this setting right VDOe2:
You can add section to custom settings for Mcu -> Nec850, Eeprom ->I24C64, Type->Unknown in group BITS
Code: Select all
<Bit>
<Offset>103</Offset>
<Index>1</Index>
<Inverted>false</Inverted>
<Description>Support Menu Enabled</Description>
</Bit>
You do not have the required permissions to view the files attached to this post.
-
- Posts: 7
- Joined: 22 Jul 2016 00:19
Re: No Support Menu option in VDO Editor 2
I added this to VDOeditor and works good.
But regarding changing in adaption, this doesn't work for me. I tried it using ODIS and gives error message of incorrect length.
So only way for me was changing eeprom.
But regarding changing in adaption, this doesn't work for me. I tried it using ODIS and gives error message of incorrect length.
So only way for me was changing eeprom.
-
- Site Admin
- Posts: 464
- Joined: 13 Jan 2014 06:18
Who is online
Users browsing this forum: No registered users and 4 guests