Has this been disabled?
I have a eeprom where this is enabled and I want to disable it, but I don't know offset.
Dear new users!
All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.
All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.
No Support Menu option in VDO Editor 2
-
- Posts: 7
- Joined: 22 Jul 2016 00:19
Re: No Support Menu option in VDO Editor 2
Should of read more....
Address is 0x67 Bit1 - Support Menu Enabled.
Address is 0x67 Bit1 - Support Menu Enabled.
-
- Site Admin
- Posts: 464
- Joined: 13 Jan 2014 06:18
Re: No Support Menu option in VDO Editor 2
Yes, this option was removed from build-in list as it is available to adjust via adaptation channel.
You can add section to custom settings for Mcu -> Nec850, Eeprom ->I24C64, Type->Unknown in group BITS
So, you can easy access this setting right VDOe2:
You can add section to custom settings for Mcu -> Nec850, Eeprom ->I24C64, Type->Unknown in group BITS
Code: Select all
<Bit>
<Offset>103</Offset>
<Index>1</Index>
<Inverted>false</Inverted>
<Description>Support Menu Enabled</Description>
</Bit>
You do not have the required permissions to view the files attached to this post.
-
- Posts: 7
- Joined: 22 Jul 2016 00:19
Re: No Support Menu option in VDO Editor 2
I added this to VDOeditor and works good.
But regarding changing in adaption, this doesn't work for me. I tried it using ODIS and gives error message of incorrect length.
So only way for me was changing eeprom.
But regarding changing in adaption, this doesn't work for me. I tried it using ODIS and gives error message of incorrect length.
So only way for me was changing eeprom.
-
- Site Admin
- Posts: 464
- Joined: 13 Jan 2014 06:18
Who is online
Users browsing this forum: No registered users and 1 guest