Dear new users!

All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.

Backlight of scales in 1008 7N0920880J

Discussions of VDOEditor utility and everything regarding VDO clusters
Post Reply
mateuszmiast
Posts: 6
Joined: 04 Apr 2019 23:52

Backlight of scales in 1008 7N0920880J

Post by mateuszmiast » 14 May 2019 14:43

Hi,

I can read in russian but writing is a nightmare for me, so replies can be in russian.

I installed 7N0920880J cluster in 2015 Scirocco instead of 1K8920875G and have problem with scales backligting. It's on only on fog and main beam lights, no backlight on scales while sidelights are on (needles are on with sidelights/main/fog etc.). It's quite annoying because my car has three additional gauges on dash (oil temp, clock/stopwatch and boost) which are backlighted even on sidelights (as was on 1K8920875G cluster).

Also I have DTC in 17 which says there is no communication with drivers door.

Is it possible to flash it with Scirocco firmware? Maybe it would help with both problems but I have no idea if I will not brick cluster.

Daku
Posts: 39
Joined: 23 Feb 2018 20:42

Re: Backlight of scales in 1008 7N0920880J

Post by Daku » 26 May 2019 21:38

Maybe scales are light up via Cluster light sensor ??

I Got That for nedles but inverted. If much light then nedles off, if low light then nedles light up

Tagfahrlicht
Posts: 5
Joined: 27 Mar 2017 22:57

Re: Backlight of scales in 1008 7N0920880J

Post by Tagfahrlicht » 13 Jun 2019 13:08

mateuszmiast wrote:
14 May 2019 14:43

Also I have DTC in 17 which says there is no communication with drivers door.

0x2F6 = 98

skodapilot
Site Admin
Posts: 294
Joined: 13 Jan 2014 06:18

Re: Backlight of scales in 1008 7N0920880J

Post by skodapilot » 15 Jun 2019 00:25

mateuszmiast wrote:
14 May 2019 14:43
I installed 7N0920880J cluster in 2015 Scirocco instead of 1K8920875G and have problem with scales backligting. It's on only on fog and main beam lights, no backlight on scales while sidelights are on (needles are on with sidelights/main/fog etc.).
Try VDOe2 2.0.0.8. There was added option to enable scales backlight in parking mode. Unfortunately, seems it is SW depended option.

mateuszmiast
Posts: 6
Joined: 04 Apr 2019 23:52

Re: Backlight of scales in 1008 7N0920880J

Post by mateuszmiast » 24 Jun 2019 11:38

Both cases done, cheers for that.
I checked also backlighting of scales while ignition off (screen on) but it's also probably depend on SW, in mine 1008 for 7N0 cluster doesn't work - backlight of needles in the same conditions work fine.

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 1 guest