VDOeditor 2.x

[skodapilot]

Не загружаются белый список, спидометры, раскладки светодиодных индикаторов и окружность колес.

Это значит, что все запросы с данного ПК блокируются на стороне сервера. О то как выйти из ситуации пишите на почту или Whatsapp

[pvc1]

v. 2.0.0.67

* Упрощенное управление пользовательскими списками битов и байтов
* Изменена подсистема лицензирования для совместимости с Windows 11

v. 2.0.0.66

* Количество датчиков на софте SW11**
* Мелкие исправления с источниками данных

[albertborsos]

FYI: for 24c64 eeproms, the immobiliser option needs a switch.
It says "Activated" when it is deactivated, and it says "Deactivated" when it is activated.

It is confusing because it worked always this way, but in a release it was correct. That is why I messed up some clusters.

Now it is wrong again. I almost messed up a cluster

[skodapilot]

Huh, i am sorry. I will add this to issues list to fix next release

Tapatalk

[zqbest]

Where to download

[skodapilot]

Where to download

To get download URL check your profile page on site https://osotec.com
If you have valid license, you will get link.

Tapatalk

[mirxas]

Issue with A3 8P 24c32 micronas cluster, when activating needle sweep/rs3 menu the glow plug indicator led doesn't work anymore, only works when doing lamp active test with vcds. Everything is ok if it is done manually in hex editor. The last cluster I did this to was 8P0920982S. In hex editor i see some random bits getting switched by vdoeditor that make no sense, needle sweep coding enabling and rs3 menu activation is not there.

[pvc1]

не могу скачать обновление 2.0.0.78, выдает ошибку

Screenshot_1.png

[skodapilot]

не могу скачать обновление 2.0.0.78, выдает ошибку

https://forum.skodapilot.com/viewtopic.php?t=365

[uncompagnero]

Issue with A3 8P 24c32 micronas cluster, when activating needle sweep/rs3 menu the glow plug indicator led doesn't work anymore, only works when doing lamp active test with vcds. Everything is ok if it is done manually in hex editor. The last cluster I did this to was 8P0920982S. In hex editor i see some random bits getting switched by vdoeditor that make no sense, needle sweep coding enabling and rs3 menu activation is not there.

Good evening to the whole group, I also have the same problem, years ago I replaced my 8P0 920 931 E cluster with red fis with an 8P0 920 932 N with white fis and also activating the rs3 menu, test needles, boost, and time when transferring data from the old cluster to the new one. Since then the glow plug light no longer comes on when starting but if I carry out tests with vcds the light works, is there a solution? Maybe activate the right bit in the 24c32? or maybe change the cluster setting from petrol to diesel, sorry for my English but I use a translator