VEditor work on Sharan cluster?

[gyozo75]

Hello.
I have Sharan Cluster 7N0920880E sw.611 this will work on editor because i don't see in whitelist?
I need to change the fuel curve,can i do with your tool?
Thank you.

[skodapilot]

Hi!
Yes, this cluster is not white listed, but, in fact, I did not see any problem to add it manually in white list, so VDOeditor will adjust working mode automatically.

Regarding curves, I am sure that there are no any differences from other SW06XX clusters and adjusting of points for sensor data and scale data is possible.
For example, data from SW06XX for single sensor mode

[gyozo75]

Ok.Thank's.
One more question,
Can i import directly only fuel curve from the cluster 5K0920870G sw.305 to Sharan cluster because i have 70L tank that's wrong and wan't to change to 55L tank to Golf?

[skodapilot]

If it is VDO cluser, yes. But I have one dump from 5K0920870G and it's Magneti Mareli cluster with absolutly different structure of EEPROM data, that VDOeditor doesn't support. I attached them.

Any case You can use any other dump with desired tank volume from vw/skoda. VDOeditor supports cross import of data: for example to SW06XX from SW03XX

To get correct working of fuel scale, You should import 55L fuel scale data too. But fuel scale data should be imported only from VW, due to Skoda and Seat use other angles of stepper motor or You should adjust value of points manualy