To make a test setup I´m searching for what signals need to go to the cluster
Brakepadweare is 15 on the cluster
Parkingbrake is pin 25 on the cluster.
but what signal do they need to test the lamps in the cluster?
are those signals only mass or do I need to supply 12Vdc positive on these pins
Dear new users!
All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.
All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.
Passat B7 cluster pin signals
-
- Posts: 32
- Joined: 02 Feb 2022 10:53
Passat B7 cluster pin signals
Last edited by dieseltje on 05 Jan 2023 12:47, edited 1 time in total.
-
- Posts: 32
- Joined: 02 Feb 2022 10:53
Re: Passat B7 cluster pin signals
No one who knowes?
Then I guess it will be trial and error.
Then I guess it will be trial and error.
-
- Posts: 32
- Joined: 02 Feb 2022 10:53
Re: Passat B7 cluster pin signals
So I tried it on old cluster and succeeded. All lights in the cluster except engine are out now.
The following pins i have connected to mass.
Pin 11 Oil temp
Pin 15 brake pads
Pin 17 front screen wash
Pin 18 coolant temp
Pin 25 parking brake
Pin 26 brake flued
Pin 27 Oil pressure
Next step is to install some pushbuttons to open the circuit, so the light actually comes on.
This will make my test setup complete.
The following pins i have connected to mass.
Pin 11 Oil temp
Pin 15 brake pads
Pin 17 front screen wash
Pin 18 coolant temp
Pin 25 parking brake
Pin 26 brake flued
Pin 27 Oil pressure
Next step is to install some pushbuttons to open the circuit, so the light actually comes on.
This will make my test setup complete.
Who is online
Users browsing this forum: No registered users and 1 guest