Hi everyone
I have replaced black and white cluster with 3D but this one have a CP (Component Protection)
is the CP are in eeprom? Can it be transfered or? I know that CP area for mib2 std PQ35 is in eeprom in 3 places but what about cluster? is it in same spots?
Thank you
Dear new users!
All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.
All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.
3d cluster CP area?
-
- Site Admin
- Posts: 464
- Joined: 13 Jan 2014 06:18
Re: 3d cluster CP area?
As far as i remember it's few bytes of immo payload
Tapatalk
Tapatalk
-
- Site Admin
- Posts: 464
- Joined: 13 Jan 2014 06:18
Re: 3d cluster CP area?
Try to contact Daku. Unfortunately, I don't remember exactly who show me screenshot from vvdi2 with comments that first bytes of data are used for CP.
Tapatalk
Tapatalk
-
- Posts: 37
- Joined: 25 Jun 2016 04:33
Re: 3d cluster CP area?
Ok, i will try
I have copied eeprom from 00001660 to 00001694 and there is no dtc in cluster about cp active, now there is ecu component protection eeprom defect, still cp active on navigation.
There is still some data that needs to be copied or corrected...
I have copied eeprom from 00001660 to 00001694 and there is no dtc in cluster about cp active, now there is ecu component protection eeprom defect, still cp active on navigation.
There is still some data that needs to be copied or corrected...
Who is online
Users browsing this forum: No registered users and 0 guests