Dear new users!

All messages from new users are moderated by administrator. Keep patience if You first message is not published, You will see it as soon as it will be accepted. Additional, new users have restriction in using of private message system.

Park Assist Error

Discussions of VDOEditor utility and everything regarding VDO clusters
Daku
Posts: 85
Joined: 23 Feb 2018 20:42

Re: Park Assist Error

Post by Daku » 24 Dec 2018 11:02

Value change in cluster eeprom offset 0x341.

For jetta try use value 03 or 08 or 0D

Yours TMPS should be disabled if there isn't wheel with sensor.

00Bob
Posts: 30
Joined: 07 Aug 2016 22:52

Re: Park Assist Error

Post by 00Bob » 27 Dec 2018 16:17

Daku wrote: 24 Dec 2018 11:02 Value change in cluster eeprom offset 0x341.

For jetta try use value 03 or 08 or 0D

Yours TMPS should be disabled if there isn't wheel with sensor.
Thanks, i will try that!!!

For your information, it's normal to have "---" when you start your car. You have to drive approximately 100m to see pressure value.

Daku
Posts: 85
Joined: 23 Feb 2018 20:42

Re: Park Assist Error

Post by Daku » 27 Dec 2018 19:23

At 3aa module and sensors data is always available even if you turn ignition only then sensors show air pressure. If you remove all whells then system set status to disabled and menu disapear :)

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests